Transparent Bridge between 2 serial interfaces on same ASR (Bridge-group command deprecated)
I have a requirement to test a system through an ASR 100X to a RS-530 Serial connected modem in loopback.
The key components are:
Anrirsu Tester (DCE) <--------> ASR <----------> Modem(Baseband in loopback)
The ASR is a single device with two connected serial interfaces, one to the tester (S0/1/0) and the other to the modem (S0/1/1), what I essentially need to do is create a transparent bridge between two interfaces on the same device.
This used to be easy on ISR running a standard IOS using 'Bridge Group #' commands, however this command has been deprecated, I have looked into BDI but this would appear to be Ethernet only, there must be some way to achieve this.
The reason for needing this is to test end to end comms on a Satcom site through the router at 8Mbps (RS-530) to carry our BER tests (BERT) over extended serial cable distances up to and including 11 metres.
Any assistance is gratefully received, if any more information is required, please let me know.
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Do you currently have hands-on networking experience? If you do, we'd love to hear from you!
Your feedback will be reviewed and analyzed by our team to directly influence a networking management and monitoring product.
Take the 20-min or les...