06-26-2019 11:03 AM
Hello i have a configured a trunk port between a Cisco and a DELL powerconnect however i cannot pass traffic
the Blue is CISCO
the Orange is DELL
What did i mis-configure? Native VLAN is 20 for DATA
06-26-2019 11:40 AM
Hello,
can you post
show interface gi1/0/1 trunk
on the cisco side?
You may need to add
switchport nonegotiate
on the Cisco side to avoid using DTP.
Hope to help
Giuseppe
06-26-2019 01:17 PM
9300#sh interfaces gi1/0/1 trunk
Port Mode Encapsulation Status Native vlan
Gi1/0/1 on 802.1q trunking 20
Port Vlans allowed on trunk
Gi1/0/1 7,10,20
Port Vlans allowed and active in management domain
Gi1/0/1 7,10,20
Port Vlans in spanning tree forwarding state and not pruned
Gi1/0/1 7,10,20
06-26-2019 01:37 PM
Dell 6200 i do not see you have configured LAG, can you post full config of both the swtches. ?
06-26-2019 01:38 PM
no LAG just 1 port connecting the two switches
06-26-2019 02:17 PM
still you need to configure as trunk right ? to allow mode vlan in the same p2p interface connection ?
06-27-2019 06:19 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: