Trunk between CAT93k and Dell 6200

[nflnetwork]

Hello i have a configured a trunk port between a Cisco and a DELL powerconnect however i cannot pass traffic 

the Blue is CISCO

the Orange is DELL

What did i mis-configure? Native VLAN is 20 for DATA

[Giuseppe Larosa]

Hello,

can you post

show interface gi1/0/1 trunk

on the cisco side?

You may need to add

switchport nonegotiate

on the Cisco side to avoid using DTP.

Hope to help

Giuseppe

[nflnetwork]

9300#sh interfaces gi1/0/1 trunk

Port Mode Encapsulation Status Native vlan
Gi1/0/1 on 802.1q trunking 20

Port Vlans allowed on trunk
Gi1/0/1 7,10,20

Port Vlans allowed and active in management domain
Gi1/0/1 7,10,20

Port Vlans in spanning tree forwarding state and not pruned
Gi1/0/1 7,10,20

[balaji.bandi]

Dell 6200 i do not see you have configured LAG, can you post full config of both the swtches. ?

[nflnetwork]

no LAG just 1 port connecting the two switches

[balaji.bandi]

still you need to configure as trunk right ? to allow mode vlan in the same p2p interface connection ?

[nflnetwork]

sorry dont understand your question
switch mode general on dell is same a switch mode trunk on cisco