Hello i have a configured a trunk port between a Cisco and a DELL powerconnect however i cannot pass traffic
the Blue is CISCO
the Orange is DELL
What did i mis-configure? Native VLAN is 20 for DATA
can you post
show interface gi1/0/1 trunk
on the cisco side?
You may need to add
on the Cisco side to avoid using DTP.
Hope to help
9300#sh interfaces gi1/0/1 trunk
Port Mode Encapsulation Status Native vlan
Gi1/0/1 on 802.1q trunking 20
Port Vlans allowed on trunk
Port Vlans allowed and active in management domain
Port Vlans in spanning tree forwarding state and not pruned
Dell 6200 i do not see you have configured LAG, can you post full config of both the swtches. ?
still you need to configure as trunk right ? to allow mode vlan in the same p2p interface connection ?