Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
375
Views
0
Helpful
1
Replies

Two Wan links on one router

nasheer.ahmad
Level 1
Level 1

‎07-28-2010 09:21 AM - edited ‎03-04-2019 09:14 AM

Dear Experts,

I have connected two wan links on one router. LAN ip subnets are configured for the fastethernets and connected to the on0e switch. Now i want to ping to the both the network ips where as it is not getting. How should i give the routing or suggest the process of configuring the same.

regds

sna

Labels:
0 Helpful
1 Reply 1

syed.raza
Level 1
Level 1

‎07-28-2010 10:40 PM

Dear Nasheer,

Please check the following and answer to better understand your issue:

  1. do u have a configured ip on the router which is part of the subnets which are on you LAN side of the router? this is required to ping from the router to the LAN IP subnets
  2. do you have a configured ip on each of the wan interface. try pinging to those ip address.
  3. how does the routing looks like?
  4. are the wan interface facing to the internet?
  5. can you share a diagram of the setup?

Answers to these questions will help me understand.

Regards

Syed

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card