cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
176
Views
0
Helpful
0
Replies

Unable to Capture outbound packets on WS - Cisco IR807

networkENG12
Beginner
Beginner

Hi All,

I'm struggling to capture outbound packets via FastEth1 on Wireshark.

I have set up a base configuration to allow connection upstream, IPSLA icmp-echo to sed upstream node is working fine. No ACL's applied and static route added.

However I can't see these outbound packets on the capture.  Can only see Ethernet II.

FastEthernet1 counters are shown below - output packets are going up but no 5 minute output rate.

Plus also seeing lots of unknown protocol drops - what could these be? What debug command can i use to show these?

Putting up on this board as there isn't much help on the web.

Can anyone help to dissect/or has faced this problem too?

FastEthernet1 is up, line protocol is up
Hardware is PQ3_TSEC, address is b0c5.3cc7.ceea (bia b0c5.3cc7.ceea)
Internet address is 192.168.71.20/24
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 1d17h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
16192 packets input, 3791491 bytes
Received 7781 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
37723 packets output, 12714066 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
5003 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
3 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out

 

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers