Trying to figure out the requirements for upgrading to PRP on a 12008. What I am trying to figure out is if my current LCs will be supported by PRP. Haven't found a page that talks about PRP compatible LC.
Thanks,
Greg
rotgsr-1#show diags | include FRU|SLOT|Memory
SLOT 0 (RP/LC 0 ): Route Processor
FRU: Linecard/Module: GRP-B=
Route Memory: MEM-GRP/LC-256=
SLOT 1 (RP/LC 1 ): 1 Port Gigabit Ethernet
FRU: Linecard/Module: GE-GBIC-SC-B=
Processor Memory: MEM-GRP/LC-256=
Packet Memory: MEM-LC1-PKT-256=
Processor Memory size: 268435456 bytes
TX Packet Memory size: 134217728 bytes, Packet Memory pagesize: 8192 bytes
RX Packet Memory size: 134217728 bytes, Packet Memory pagesize: 8192 bytes
SLOT 2 (RP/LC 2 ): 4 Port Packet Over SONET OC-3c/STM-1 Single Mode
FRU: Linecard/Module: LC-4OC3/POS-SM=
Processor Memory: MEM-GRP/LC-256=
Packet Memory: MEM-LC-PKT-128=
Processor Memory size: 268435456 bytes
TX Packet Memory size: 67108864 bytes
RX Packet Memory size: 67108864 bytes
SLOT 3 (RP/LC 3 ): 6 Port Packet over DS3
FRU: Linecard/Module: 6DS3-SMB-B=
Processor Memory: MEM-GRP/LC-256=
Packet Memory: MEM-LC-PKT-128=
Processor Memory size: 268435456 bytes
TX Packet Memory size: 67108864 bytes
RX Packet Memory size: 67108864 bytes
SLOT 5 (RP/LC 5 ): 4 port ATM Over SONET OC-3c/STM-1 Single Mode
FRU: Linecard/Module: 4OC3/ATM-IR-SC=
Processor Memory: MEM-GRP/LC-128=
Packet Memory: MEM-LC-PKT-128=
Processor Memory size: 134217728 bytes
TX Packet Memory size: 67108864 bytes
RX Packet Memory size: 67108864 bytes
SLOT 16 (CSC 0 ): Clock Scheduler Card(8)
FRU: Linecard/Module: GSR8-CSC/ALRM=
SLOT 17 (CSC 1 ): Clock Scheduler Card(8)
FRU: Linecard/Module: GSR8-CSC/ALRM=
SLOT 18 (SFC 0 ): Switch Fabric Card(8)
FRU: Linecard/Module: GSR8-SFC=
SLOT 19 (SFC 1 ): Switch Fabric Card(8)
FRU: Linecard/Module: GSR8-SFC=
SLOT 20 (SFC 2 ): Switch Fabric Card(8)
FRU: Linecard/Module: GSR8-SFC=
SLOT 24 (PS A1 ): DC Power Supply(8)
FRU: Linecard/Module: PWR-GSR8-DC=