cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
421
Views
0
Helpful
4
Replies

urgent help with pim sparse rp plz

Farooq Muhammad
Level 1
Level 1

Hi all,

i have a network with pim sparse-dense-mode and rp is configured statically with an access-list combination for some groups rest all multicast is using dense.

For some testing i configured another device as rp for all applications which immediately over ride the old rp and the new became rp for all groups.i removed the latest config but still after clearing mroute table and clearing ospf the said device along with all other devices show the new rp as the final rp.

is there any way to clear this

plz respond.

1 Accepted Solution

Accepted Solutions

Hello,

Thank you. Have you tried using the clear ip pim rp-mapping command? After entering it, would you be so kind to check the

show ip pim rp

show ip pim rp mapping

commands to see if the deleted RP still remains in the mapping cache?

Best regards,

Peter

View solution in original post

4 Replies 4

Peter Paluch
Cisco Employee
Cisco Employee

Hello,

Did you configure the new RP statically using the ip pim rp-address or was it discovered automatically using AutoRP or BSR?

Best regards,

Peter

new one was statically configured and now removed .

Hello,

Thank you. Have you tried using the clear ip pim rp-mapping command? After entering it, would you be so kind to check the

show ip pim rp

show ip pim rp mapping

commands to see if the deleted RP still remains in the mapping cache?

Best regards,

Peter

Farooq Muhammad
Level 1
Level 1

Thanks Peter,

clear ip pim rp-mapping and clear ip mrout * worked but the problem was that i have to manually clear these entries on all layer three devices in my multicast domain.It was really hard time for me as badly hanged all our multicast applications.

Best Regards.

Review Cisco Networking for a $25 gift card