Hello all.
i seem to have an issue with my GW to GW setup between my 2 x Cisco RV320’s (one at home and one in the office). The tunnel is up and it always stays connected but I can’t connect to devices from either when I could before. My office RV320 does have a LAN to LAN IPSec Tunnel to a Draytek router and that seems fine.
If I reboot my home RV320 I can connect back to the office ok but this only lasts for about 2 min and then it goes again. Has anyone got and ideas? The one thing that has change is I have a new internet service, the firewall is the same from when it worked, it’s on the lastest firmware and the router for the new internet has turn of the ACL that Denys any access.
its strange as it was working and not I can’t get it back up