11-15-2009 03:19 PM - edited 03-04-2019 06:43 AM
Hello All,
I'm issues configuring the OSPF for a specific VRF instance. I get the following error (using 3700 12.4(15)T11)
VRFRTR(config)#ROUTER OSPF 100 VRf STUB
%VRF specified does not match this router
However when I configure the address family in EIGRP, ti works.
VRFRTR(config)#router eigrp 12
VRFRTR(config-router)#address-family ipv4 vrf STUB
VRFRTR(config-router-af)#exit
Here is the output of show ip VRF:
VRFRTR#show ip vrf
Name Default RD Interfaces
NSSA 30:30 Se2/2
Se1/2
STUB 10:10 Se2/0
Se1/0
TSNSSA 40:40 Se2/3
Se1/3
TSTUB 20:20 Se2/1
Se1/1
VRFRTR#
Any Ideas what im missing? .. I've attached my router configuration.
(btw this is a home lab for CCIE W test. Trying to be smart using VRF's to simulate 8 routers using only 3 routers.)
11-15-2009 04:21 PM
Merrylle,
Can you post "sh ver" here?
Reza
11-15-2009 09:22 PM
I figured out the problem. I was copy and pasting the VRF lines. Not sure why when i typed it in it worked.
- I did verify copy and paste does not work.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: