cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1282
Views
0
Helpful
2
Replies
Highlighted
Beginner

VWIC2-1MFT-G703 in Cisco 2921 router

                   Hi there,   I have installed a VWIC2-1MFT-G703 module into cisco 2921 router, I can verify the card by show inventory command. but in show run, I do not see the E1 controller card there. this card is used for TPG lease line for data only.  Can some advice if those card is compatable with new 2921 router?  or need some extra command to bring it up?  many thanks in advance.  Roy

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Master

Configure card-type.

View solution in original post

2 REPLIES 2
Highlighted
Hall of Fame Master

Configure card-type.

View solution in original post

Highlighted

thanks, Paolo,   I thougt  card-type only needed on E1/T1 card, seem to me I am wrong with 2921. it worked.  many thanks. R