05-03-2010 01:42 AM - edited 03-04-2019 08:21 AM
Hi,
is it possible to run ppp encapsulation with a VWIC2-2MFT-T1/E1 interface?
Tia,
Stephan
05-03-2010 12:42 PM
Yes, of course.
05-03-2010 11:15 PM
Ok, i'll refine my question. How can i configure ppp encapsulation on VWIC2-2MFT-T1/E1 with IOS advipservicesk9-mz.124-17a? If i paste the command encapsulatio ppp i get %Hardware does not support the encapsulation. I got many information that the VWIV ist able to run with ppp, but obviously it requires something more.
Hope somebody knows the answer.
Stephan
05-03-2010 11:27 PM
What? It Cann't Be!
Let me show you some config:(this router use ipbase ios,and it is running)
card type e1 0 0
controller E1 0/0/0
clock source internal
channel-group 0 unframed
interface Serial0/0/0:0
description toHQ
ip address 10.1.1.2 255.255.255.252
encapsulation ppp
load-interval 30
you should chek your config .
05-04-2010 03:55 AM
Try the following
http://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/intserv.html#wp1050939
Otherwise use the specific data cards for ISDN calls.
05-03-2010 11:20 PM
you can use ppp or hdlc(hdlc is default option) encapsulation .
when two sides use the same encapsulation option,anyone can go.
05-03-2010 11:53 PM
Ok, here are the parts of my config:
card type e1 0 0
!
isdn switch-type primary-net5
!
voice-card 0
no dspfarm
dsp services dspfarm
!
username XXX password XXX
!
controller E1 0/0/0
pri-group timeslots 1-31
description *** Voice ***
!
controller E1 0/0/1
pri-group timeslots 1-31
description *** ISDN-Backup ***
!
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
no cdp enable
!
interface Serial0/0/1:15
description *** ISDN-Backup Arcor ***
no ip address
encapsulation hdlc
dialer pool-member 2
no snmp trap link-status
isdn switch-type primary-net5
isdn answer1 xxxxxxx
isdn calling-number xxxxxxx
isdn sending-complete
!
interface Dialer100
description *** ISDN-Backup ***
ip address 10.x.xxx.xx 255.255.255.254
encapsulation ppp
ip summary-address eigrp 597 10.x.xxx.xx 255.255.252.0
ip summary-address eigrp 597 10.x.xxx.xx 255.255.252.0
dialer pool 2
dialer remote-name xxxxx
dialer string xxxxxxxxxxxxxx
dialer hold-queue 5
dialer load-threshold 40 either
dialer-group 1
no snmp trap link-status
ppp authentication chap
voice-port 0/0/0:15
!
voice-port 0/0/1:15
Port 0/0/0 is configured for voice, and 0/0/1 should be configured for isdn backup.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide