cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
429
Views
0
Helpful
1
Replies

Wan without bgp

Mary
Level 1
Level 1

I have two Wan circuit, we didn't run bgp on the gateway, we only run ospf, so how to configure the gateway active/standby failover? Thanks

1 Reply 1

Mark Malone
VIP Alumni
VIP Alumni
setting the ospf cost to very high both ends will make one of the links less preferred in same ospf area
if the metrics and cost match on each link you can have active /active by default with ospf
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco