Hello,
I have purchased Cisco 3845 and have problems to boot it without problems.
To be more precisely i am getting "Watch Dog Timeout Reset" and box is constantly rebooting itself.
------ log 1 --------------------------------------------
System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2006 by cisco Systems, Inc.
System Bootstrap, Version 12.4(13r)T11, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2008 by cisco Systems, Inc.
Total memory size = 512 MB - DIMM0 = 512 MB, DIMM1 = 0 MB
c3845 platform with 524288 Kbytes of main memory
Main memory is configured to 72/0(dimm 0/1) bit mode with ECC enabled
Upgrade ROMMON initialized
program load complete, entry point: 0x8000f000, size: 0xcb40
program load complete, entry point: 0x8000f000, size: 0xcb40
program load complete, entry point: 0x80010000, size: 0x2212d64
Self decompressing the image : ################################################################################################################################################################################################################################################################################################################################################################################################## [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
00042C 0X010D78F3 C3845 motherboard
0X00280000 OIR memory
0X00288860 Onboard PVDM2 SIMM
0X000021B8 Onboard USB
0X00660670 public buffer pools
0X0078F000 public particle pools
TOTAL: 0X023D197B
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 36Mb.
Using 7 percent iomem. [36Mb/512Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, 3800 Software (C3845-SPSERVICESK9-M), Version 12.4(9)T7, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Thu 10-Jan-08 18:36 by prod_rel_team
Image text-base: 0x60011084, data-base: 0x62CE4190
System Bootstrap, Version 12.4(13r)T11, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2008 by cisco Systems, Inc.
*** Watch Dog Timeout Reset ***
ra = 0x603cd1f0, EPC = 0x603cd1f0
*** BCM 1125 went through a full reset. HT/PCI fabric reset. ***
------ log 1 --------------------------------------------
Here are few steps that i have aleady done to solve this:
1) use different CF with the same result
2) use few IOS c3845-ipbase-mz.124-18.bin, c3845-ipvoicek9-mz.124-17.bin,
c3845-ipvoicek9-mz.124-22.T.bin, c3845-spservicesk9-mz.124-13c.bin with the same result
3) tried to boot IOS from rommon mode with exactly the same after-effect
4) checked if cookie is okay. Unfortunately i cannot say that the whole cookie is okay, but beginning octets are not FF's.
cookie:
04 ff c1 8b 46 4f 43 31 33 32 38 36 32 4d 52 40
04 2c 41 01 04 c0 46 03 20 00 5c 40 07 42 43 30
88 00 01 8e fa 02 05 03 00 81 00 00 00 00 04 00
09 69 c6 8a 49 50 4d 4e 58 30 30 44 52 41 cb 8c
43 49 53 43 4f 33 38 34 35 2d 4d 42 89 56 30 37
20 d9 02 40 c1 c3 06 00 26 0b d3 90 10 43 00 30
82 49 22 5f 0a 83 01 32 8f 5b c2 8b 46 54 58 31
33 33 31 41 4a 42 42 ff ff ff ff ff ff ff ff ff
Could you please tell me where to look for "Chassis MAC Address" so i can compare? - first octets?
5) tried to upload ios from rommon mode without success. See logs below:
------ log 2 --------------------------------------------
rommon 3 > IP_ADDRESS=192.168.1.5
rommon 4 > IP_SUBNET_MASK=255.255.255.0
rommon 5 > DEFAULT_GATEWAY=192.168.1.1
rommon 6 > TFTP_SERVER=192.168.1.10
rommon 7 > TFTP_FILE=c3825-spservicesk9-mz.124-24.T.bin
rommon 8 > tftpdnld
IP_ADDRESS: 192.168.1.5
IP_SUBNET_MASK: 255.255.255.0
DEFAULT_GATEWAY: 192.168.1.1
TFTP_SERVER: 192.168.1.10
TFTP_FILE: c3825-spservicesk9-mz.124-24.T.bin
GE_PORT: Ge0/0
TFTP_MEDIA_TYPE: Copper
GE_SPEED_MODE: Auto
Invoke this command for disaster recovery only.
WARNING: all existing data in all partitions on flash: will be lost!
Do you wish to continue? y/n: [n]: y
Mac Address: 0026.0bd3.9010
Receiving c3825-spservicesk9-mz.124-24.T.bin from 192.168.1.10 !!!!!!!!!!!!!!!!!!!!!!!!
....................
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
File reception completed.
TFTP flash copy: Invalid file header, copy terminated.
Reason: Wrong target platform OR corrupt file.
------ log 2 --------------------------------------------
6) Removing PVDMs did not change anything
I have no idea how to solve this.
Could anyone give me advice.
Regards,
Maciej
