cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
672
Views
0
Helpful
1
Replies

WCCP issue with virtual-template 1 on ASR 1001

kashalo84
Level 1
Level 1

Hi all

am trying to configure the wccp on virtual template but when i added the follwoing command in virtual-template configuration i get the following error.

LNS-3(config)#inter virtual-template 1

LNS-3(config-if)#ip wccp 80 redirect in

Jan 22 18:48:19.683: %IOSXE_WCCP-4-NOINTF: No Virtual-Template1 interface info for Service Group (1, 80, 0)

-Traceback= 1#f3458ff72c5f00e4e4a20998f488c178  :400000+1271923 :400000+5A11016 :400000+35E7DD5 :400000+35E774F :400000+116B298 :400000+116A99D :400000+1168945 :400000+40255C0 :400000+1197CB0 :400000+11994A1 :400000+1198CF8 :400000+11966DB :400000+1196541 :400000+11961FB :400000+1183858

and then the follwing error always popup

Jan 22 18:48:26.326: %FMANRP_ESS-4-FULLVAI: Session creation failed due to Full Virtual-Access Interfaces not being supported. Check that all applied Virtual-Template and RADIUS features support Virtual-Access sub-interfaces. swidb= 0x7FFDA39236F8, ifnum= 41

any help please

1 Reply 1

Hello,

The "%IOSXE_WCCP-4-NOINTF: No Virtual-Template1 interface info for Service Group (1, 80, 0)" notification is due to a cosmetic bug CSCtc01098. No impact or actual issue. I suggest you upgrade to 3.10s or later.

The "%FMANRP_ESS-4-FULLVAI:" is due to a RADIUS attribute "Framed-Compression" that is set to Van-Jacobsen-TCP-IP. This will cause the ASR1K to use Full Virtual Access Interface. Unfortunately this is not supported on the ASR 1000 as is.  For a workaround look at the following guide:

http://www.cisco.com/en/US/docs/routers/asr1000/configuration/guide/chassis/scaling.html#wp1124018

HTH,

Michel.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: