DMVPN Tunnel for backup path to voice server to Data Center A
P2P GRE Tunnel for Business Applications to Data Center B
The router has G0/0 connected to LAN and G0/1 connected to any flavor ISP circuit (DSL, Cable, etc etc)
My issue is I am not very clear where to apply my QoS to on this setup. The one requirement we have by our data center folks in Data Center B is that we apply a shaping policy to the P2P GRE tunnel at their purchased rate in steps of 1.544Mbps. So an example would be this customer purchased speed to the data center of 1.544Mbps, so a shaping policy is applied to the GRE Tunnel to restrict this.
So Business traffic on GRE, Backup Voice Traffic on DMVPN, and General Internet browsing on G0/1. I need to provide adequate QoS settings to match the requirement of Data Center B and also protect Voice traffic from getting squeezed out by Internet traffic.
Based on this information where is the best place to apply QoS?
The only thing I can come up with is, shape the upload bandwidth of the ISP service and build a policy within that shaper? But how can I also keep the Data Center requirement of keeping GRE traffic at its allocated amount?
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...