Why doesn`t pinging?

[gastrit]

Why WS1 can`t ping SW1,SW2,SW3 switches? OSPF is enabled. pkt in zip below. thanks

[daniel_growth]

Hey,
Your PC doesnt have IP, subnet or default gateway configured.

Correction* your using IPV6, my bad :)

Your OSPF isnt configured from what I can tell. When running show ip ospf neighbour, interface and database nothing is populated.

[gastrit]

How I suppose to solve this?

[daniel_growth]

you need to add the adjacent networks into ospf so that they become neighbours.
I recommend reading http://www.ciscopress.com/articles/article.asp?p=26919&seqNum=3

You need to add the networks.

ipv6 router ospf 1

Then

network (IP) (wildcard) area 0

doe this on all routers and they should establish neighbours

[gastrit]

There is no network command.

[secureitgroup]

That is correct ipv6 does not have a network command, there is a slight configuration shift to IPv6 and you have discovered one of the small differences.

[gastrit]

what exactly I need change in my configuration?

[Leo Laohoo]

To all concerned,
Clearly this thread is school work.
Help the students learn: Post the links to documents and configuration guides.
Please refrain from handing out answers.

[Mahesh72755]

Here is the guide for configuring ospf

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_ospf/configuration/xe-16/iro-xe-16-book/iro-cfg.html

[Georg Pauwen]

Hello,

there were no IPv6 links between the switches, so they could not form an IPv6 OSPF neighborship with each other. I have added the links to all switches, you should have full connectivity now...

[gastrit]

The main point of this network is using port-channel connections. Do I really need more links for full routing?

[Georg Pauwen]

If port channels are required, make them layer 3 port channels, so you can assign an IP address. There needs to be a layer 3 link between the switches for OSPF to work.

[gastrit]

I can`t find tutorials to do this

[Georg Pauwen]

Hello,

what is the requirement for your project ? Do you need for the routed interfaces to all have IP addresses from a different subnet, or can it be the same subnet ?

[gastrit]

I need working PAgP and IPv6.