cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1319
Views
0
Helpful
2
Replies

Wierd symbols when trying to connect through console (SG500-28-K9-G5)

Erik Hennerfors
Level 1
Level 1

Hi I have a SG500-28-K9-G5 at work and I'm tyring to connect to it trough the console port via Putty and get wierd symbols:

When I press any button I see alot of wierd symbols comming up, for example if I press shift+6 or Enter (or anything).

Image:

http://public.gonace.com/putty.jpg

Settings:

Speed (baud): 9600

Data bits: 8

Stop bits: 1

Parity: None

Flow Controll: None

Keyboard: VT100+

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Searching forums or all the internet, there are few thousands of hits for cases identical to your, most cases give the correct solution, have you tried searching ?

Yes I've done that but none of the about 10 solution worked for me, I've even factory rresetted the device, tried multiple console cables on multiple laptops.

If I hadent try the solution I could find I would not write the question in this forum.

Review Cisco Networking for a $25 gift card