03-08-2013 11:43 AM - edited 03-04-2019 07:14 PM
Please see the attached design for my dilema.
Thanks,
Desmond
03-08-2013 02:47 PM
Why not just remove the HSRP config?
03-08-2013 05:09 PM
Thanks vmiller for responding!
My current setup does not include the switch that is in the diagram and currently if I lose (hardware failure) the primary 2911 router, Hsrp will fail over to the secondary 2911 and also the 2nd Wan link, a good basic backup solution. I have two separate paths and that works fine but I dont want to fail over to Link 2 just because the primary 2911 is gone, I want to add a switch to the mix and if that primary 2911 fails I want it to then use the secondary 2911 to get to London but still using Link 1 to get back to the USA.
Is that scenario possible with just adding a switch between the comm element and the primary 2911 router?
Thanks again,
Desmond
03-10-2013 12:28 AM
Hi Desmond
I don't think you need switch in betweeen primary WAN router, better to remove HSRP and do static routing on WAN routers to route traffic.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide