MDF switch has a static route of a gateway of last resort pointing to GLBP IP. AP has picked up IP address from its scope (10.2.26.0/24) and i see several wireless users has already got correct IP aswell in DHCP server. My main question is..... Since WAN LAN IP and Wired VLAN are in the same scope....do i need to create another virtual interface and configure GLBP in WAN routers for the wireless VLAN ? or this setup will work as well?
Also how did AP & wireless users got correct IP from their scope since WAN LAN IP is the same scope as wired VLAN & there is no WAN LAN IP with wireless vlan scope. I thought i need another LAN port in WAN with same scope as wireless VLAN for this to work.
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...
good morning I have this report from users, saying that they encounter connection issue only when they are wired , but the wireless I fine. both connection are using the same path to the internet ...please advised a troubleshooting plan.