I just put a 6182 controller card in my Cat6500 - when I set the 10/0/0 timeslots I don't get a
interface Serial10/0/0:0 - Like I would normaly see from a controller card. They only thing I see is
interface Port-channel10
no ip address
controller T1 10/0/0
channel-group 0 timeslots 1-14
description XXXX
!
controller T1 10/0/1
channel-group 0 timeslots 1-24
!
controller T1 10/0/2
!
controller T1 10/0/3
.........
The Port channel - show ? I am not familar with this can someone explain?
Port-channel10 is up, line protocol is down (notconnect)
Hardware is EtherChannel, address is 000d.662c.ea8a (bia 000d.662c.ea8a)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00