Hello,
There is a WS-X6708-10GE installed on 6509 with below status.
6509#sh module 9
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
9 8 CEF720 8 port 10GE with DFC WS-X6708-10GE SAL1201BZ7J
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
9 0018.b967.2338 to 0018.b967.233f 1.3 12.2(18r)S1 12.2(33)SXH8 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
9 Distributed Forwarding Card WS-F6700-DFC3CXL SAL1106GGV7 1.0 Ok
Mod Online Diag Status
---- -------------------
9 Pass
The temperature of ASICs on this module seems to be high but I can't find the threshold value. Is this temperature OK or NOT?
6509#sh environment temperature module 9
module 9 outlet temperature: 61C
module 9 inlet temperature: 47C
module 9 aux-1 temperature: 59C
module 9 aux-2 temperature: 50C
module 9 asic-1 temperature: 88C
module 9 asic-2 temperature: 81C
Below command shows some threshold except ASICs threshold.
6509#sh environment alarm thresholds module 9
module 9 power-output-fail: OK
threshold #1 for module 9 power-output-fail:
(sensor value != 0 ) is system minor alarm
module 9 insufficient cooling: N/A
threshold #1 for module 9 insufficient cooling:
(sensor value != 0 ) is system major alarm
module 9 outlet temperature: 61C
threshold #1 for module 9 outlet temperature:
(sensor value >= 75C) is system minor alarm
threshold #2 for module 9 outlet temperature:
(sensor value >= 85C) is system major alarm
module 9 inlet temperature: 47C
threshold #1 for module 9 inlet temperature:
(sensor value >= 55C) is system minor alarm
threshold #2 for module 9 inlet temperature:
(sensor value >= 65C) is system major alarm
