HI Experts.I know the threshold value can be between 1% and 5% packet loss. Do you know whether the Cisco SDWAN FEC Loss threshold is for line packet loss or TCP packet loss?FEC Adaptive—Only send Forward Error Correction (FEC) information when the ...
what are the minimum resources to run a simple SD-WAN Lab?Thanks in advance
What is Webhook URL and Webhook URL execution username of alarm notifications of Vmanage at alarm Tab?
Hi, We have an issue where users are losing their DNS on MacOS 12.3.x. They have anyconnect client 4.10.05 installed and with only the VPN component. It's a bit of a weird issue as it seems to be sporadic and happens at random times.It doesn't matte...
Hello, We have a Cisco ISR4431/K9 that now requires the DNA / SD-WAN solution. I understand we must purchase the L-DNA-TIER-ADD license for this router. But then is the subscription (like DNA-C500M-A-3Y) a separate purchase? The original BOM for the...
1.If We have 100 WAN edge devices on Vmanage Dashboard but we see 102 count on control status of Vmanage Dashboard.Please specify reason about seeing 2 extra count in control status of Vmanage Dashboard everytime as control status denotes control co...
Can we see routing table on Vsmart or Can we see just OMP peering ?and reason also please let us know with any document
Can we get any link to where there is guide to use Vmanage tool from cisco?I clicked on on main dashboard and there are total 279 Vedge device with one down and 278 UP.what is control status and site health in dashboard?control status is 281 only and...
if we have service VPN 10 at Dubai Vedge and service VPN 20 at India Vedge then Can they talk to each other by default?I think VPN is like VRF concept so do we have to keep same VPN ID at both end by default?and one interface is member of one service...
Hi vEdge1 and vEdge3 are connected like first below picture. After vIOS1 send extend ping to vIOS3, we got data flow info from vManage like the below second and third picture. We get data flow info from vEdge01 and vEdge02 via vManage as below: Ba...
Hi Please see the first below picture. I am trying to see DPI Aplication traffic flow after sending a big ping packet from device behind the vEdge, but it shows "No data to desplay". Did I miss some step? The second picture show some flow that I want...
Hi We have the below topology where ospf are configured at all devices. vEdge1 can see route 2.2.2.2, but R1 cannot see it. Is this normal? Can we let R1 see 2.2.2.2? Thank you 1.1.1.1-R1 ----vEdge1-----vSmart-----vEdge2-----R2-2.2.2.2
Hi Three vedges are fully connected and can ping each other. Device template are attached to each vedges successfully. But peer can not be seen. Please see the below. Anyone can share some experience or some suggestion? Thank you!
Hi Please see the below screenshot. After attaching device template, it shows out of Sync. Looks like template configuration and original one are different, and finally roll back. So what can cause the the issue? Thank you
Hi Please see the below picture. Three vEdge are registered at vManage and are verified via certificate. but its status are still in "Partial" . Where the issue is? Thank you
