SD-WAN and Cloud Networking

While doing Cisco SDWAN cEdge routers configurations, we are unable to configure IPV4 address. We can only option of IPv6 address. Need help to configure IPV4 address. Thanks sdwaninterface GigabitEthernet0/0/0ip address 172.21.26.10 255.255.255.252 ...

In my environment we have multiple cEdge devices, 1 vManage, 2 vBond and 2 vSmart.Due to some reasons one of the cEdge devices lost connectivity to vMange. Not sure of the exact reason.But would like to understand, will there be any impact due to thi...

In my environment I have 2 vSmart controllers. (vSmart-1, vSmart-2)In cEdge-1, the OMP peer is established only with vSmart-1. No details about peering with vSmart-2.in cEdge-2. the OMP peer is established with vSmart-1, for vSmart-2, the status is i...

Can we use same IP Address for Sysem IP and VPN 0 of a vBond and vSmart

In scenarios where there are 2 vBonds, how the redundancy works ?In normal scenarios, are both the vBonds are active - active or active - standby.How the redundancy works in case of failure of 1 vBond ?

For the below commad in cEge, in normal scenario it should show only vSmart and vMange.Plse claify if myunderstandng is correct ? Does vBond will be visible in the output ? show sdwan control connections 

If a cEdge has 2 internet connections & there are 2 vSmart & in this scenario how many control connections will be establisehed.Will it be 4 or 2 ? 4 means each internet link IP wll form connection with both the vSmart, so there should be 4.Is my und...

Dear All Friend and Experts, We have two site :Site A & BVP0 is transportVPN 10 is services VPNhoSite A has a Server IP is x.x.x.xSite B have two clien are 1.1.1.1 and 1.1.1.2Two Tunnel , Two TLOC color biz-internet and pub-internet Now my customer t...

In my environment the OMP Graceful Restart timer is set to 7 days.If the vSmart is down, with the above the cEdge will have the routes till 7 days.After 7 days the routes will flush and the dataplane will be down.My question is assuming the vSmart is...

Hello experts, I have a question in SD-WAN about what happens if you define an interface template with TLOC preference in this way:encapsulation ipsec preference 200 weight 1And parelly you also define a Central Policy with a TLOC statement where you...

Sign up for the SD-WAN Interconnects EFT today! We’re thrilled to announce that SD-WAN Interconnects is now available for private beta & early field trial (EFT). Customers using both Meraki and Catalyst SD-WAN can now enable transit between VPN fabr...

Is it possible to build an IPSec VPN tunnel between a cEdge device and Zscaler with the source of the tunnel being in the service VPN say VPN 5 rather than VPN 0?

HiI am trying to upgrade virtual image(UTD) with ISR1111X-8P by SD-WAN vmanage.But it fails with the message "Following devices do not have container software services"How can I solve this?

Hello,SSH service is activated on vpn 0 under interface ge0/0. The SSH stopped working after I activated the NAT on the same interface!. Does anyone know why? thank you