Hi Experts I am trying to set a sort of L2VPN between two vEdges using the Bridge functionality, however i have not had success yet.I got the bridge interfaces up on both sides , and also each of the laptops MAC addreses are being recognized, but jus...
Forum Posts
What is the difference between BFD sessions VS OMP sessions
What are the primary types of traffic that typically traverse VPN 0 in an SD-WAN deployment?How does the prioritization of traffic differ within VPN 0 compared to other VPN tunnels in the SD-WAN architecture?tunnel interfaceservice vpns
Hi , We use Cisco VPN and the SBL (start before login module) this works flawlsy but when the user locks his screen/auto lock there unable to get back in due to secutiry policys preventing Cached profiles and thus cannot login after a system locks , ...
Hi,I am doing an upgrade for vManage devices. It does the upgrade but sometimes doesn't set the default version for a specific device.This issue never happens on downgrade."Change Partition action submitted for execution","Executing device action Cha...
Hi everyone, I have built the controller on-prem for lab. In the ver 20.3 everything is ok but when I upgrade vManage to 20.6, I can not push the template to WAN Edge Device, the error code is below: Server error: no registration found for callpoint ...
Resolved! ISR4331 cEdge assistance
Dear Community,I am manually trying to onboard a 4331 onto our SDWAN Fabric. I am in the process of getting the underlay configured (WAN IP, Default Route, DNS server etc.). I have dozens of these in the past with no issues. However, this router is h...
Resolved! Unable to validate certificate
Dears, i am getting the below errors any idea how to resolve it, the root cert is already installed.\ [28-Apr-2024 11:05:42 UTC] Install Certificate, on device caaaa438-ce6e-4afa-8b69-b896782de3f5, started by user "admin" from IP address "10.255.1.5...
Hi all, I'm running a 20.9 sd wan home lab with Cloud vEdges, I have a dual site (one of 4) with OSPF running on the LAN side where I have a L3 switch doing as a core.I have 3 VPNs (100, 300, 400) which are mapped to respective ospf process with vrf ...
Hi All, I've been googling around to discover various tools around Cisco SD-WAN automation. I read about the Sastre tool, the Python Catalystwan SDK and a couple of other (but older) tools. Actually I was looking for a tool that would allow to manipu...
I want to know ways to change behaviour for one site. For example for site 10 (originator 1.1.1.204) where mpls has higher preference than Internet only for site 10, But can't find decision to do it when I have common policy for all of my sites. I k...
Hello guys, Need some understanding about VPN0 vs sub-interfaces design. .. at DC design point of view i have one traditional MPLS link connect directly to the sdwan, and one public internet that i want to pass through FW. i know that is possible to ...
Our Cisco 8300 routers were limited to 250mbps.. so we applied the license to vmanage and it took..it just has not upped the 250mbps limit like it should have.. no error messages no warnings...any ideas?
What is the harm in extending the Graceful-restart time from the default 12 hours to 7 days or so?
Hi,We need to migrate from fortinet firewall to Meraki MX240 firewall. Can someone please suggest how to do this along with the procedure?Currently, there are access policies,NAT amd IPSec VPN in fortinet. Is there any dependency to configure these t...
