Is there any alternative or new syntax to have the same result for the following command? ( on Vedge and Cedge)track 1 ip sla 1 reachabilityand then use Show track brief to monitor the track.
Forum Posts
Hello,Currently we're on DMVPN for our WAN and migrating to Cisco sd-wan as a replacement. Currently, all dmvpn sites reach the Internet from our data center, hence, the DC advertises a default route. At the current design, the sdwan has to be able t...
Hi GuysI need help to configure the Static NAT on the vEdge router to allows the external access to the internal servers. The vEdge has two Internet links from different service provider and DIA is enable by using Data Policy. In the Static NAT setti...
I would need help to know some useful Debug Commands that can be performed for troubleshooting purpose.also an example of their output.examples on topics to troubleshoot:1- only Vsmart Flapping randomly with underlay connection fine.2-IPSEC tunnels ...
Somebody, please explain this to me. In vManage I update a template; the update fails and you see output similar to this:1-Sep-2022 13:00:40 UTC] Failed to update configuration - Error on line 151: invalid value for: prefix in /devices/device/config/...
I am trying to create a vManage cluster on different subnet using version 20.6.3 on esxi (I know it is not recommended, however, that is how it was requested. I even got it to work in my lab on eve-ng using the same version). The issues I am facing ...
Hi, Introduction: I have a SDWAN setup in which I am already using HUB & SPOKE scenario. Like whole network we distributed in 4 zones Zone-A ,Zone-B, Zone-C, Zone-D > Every Zone having multiple SD-WAN sites > For Inter-Zone communication is happening...
I am trying to get dual-stack set up in my lab environment, but I am having issues with IPv6 link-local addresses. For the config, I am adding a second IPv6 address in the interface template as a static variable. I do not see a way to add "link-local...
What is Root Certificate and ID_Certificate in Viptela SDWAN?
Customer has a hub and spoke Viptela network. Hub sites have 2 transports, mpls and lte. Customer wants to prefer the mpls color to egress out all traffic, unless the remote site only has an lte connection. If remote site only has an lte connection t...
hello, We are planing to Migrate MPLS wan Network into SD WAN ,Can we Installed vBond , Vmanage and vSmart other than UCS server . We have Already installed ESXI on other hardware . If my network have multi vendor routers then can we implement Cisc...
Hi all, A quick question: is there some kind of limitation in the cisco managed AWS cloud that prevents me from setting a static IP? Reason: we lost one vsmart last night for a short duration because it wasn't getting a lease. Also, its logs are full...
Hi,I have below error when I tried to upgrade software of our vEdge1000 using CLI from 20.3.3 to 20.6.3.What is causing this error and how can I fix it? Thank you, vedge# request software install /home/admin/viptela-20.6.3-mips64.tar.gzgzip: invalid ...
Hi Is it possible to apply time-based SD-WAN policy(ex> data or app-aware policy)?For example, certain traffic takes a specific link applied by a data policy during 9am - 5pm.
Was trying to connect to vManage GUI for about 1h but couldnt.note: ping requests are successful.request nms all status command result:Problem
