Loading current IOS on 100b vEdge

[benwexler1]

I have some 100b with older code 15/16.x and vMAnage will not recognize them. How do I manually update the code to 19.x or are there a series of commands to force it to recognize vMange?

thanks in advance,

Ben

[svemulap@cisco.com]

Ben -

15.x is really old. Going back to Viptela days of 2015 !!
You need step upgrade, so vEdge can talk to vManage on 19.x version.
It requires at a high level to go from 15.3.8 -> 16.2.10 -> 17.2.8 -> 19.x 9
(some thing like it)
Some of these images are not even posted anymore on cisco.com<>

Best option is open a TAC Case on this to get the vEdge to an image where it can talk to vManage.

Hope it helps.

[benwexler1]

Thank you for the reply. Same recommendation for the units on 16.x code. 

My next step was a TAC case.

thanks again 

Ben

[svemulap@cisco.com · Accepted solution]

Yes, Ben.
Same applies for 16.x too.
The latest image that is available on CCO Software download page is: 18.4.4

Hope it helps.