Hello,
I 'm having a problem accessing the GUI Interface of the Viptela vManage controller v20.4.1. the application server is waiting even when I restarted it.
-------------
vManage# sh int vpn 512
interface vpn 512 interface eth1 af-type ipv4
ip-address 192.168.2.101/24
if-admin-status Up
if-oper-status Up
encap-type null
port-type mgmt
hwaddr 50:00:00:04:00:01
speed-mbps 1000
duplex full
uptime 0:01:39:38 <<<<<<<
rx-packets 321
tx-packets 150
--------------------------
vManage# request nms application-server restart
Successfully restarted NMS application server
vManage#
vManage#
vManage# request nms application-server status
NMS application server
Enabled: true
Status: waiting
-----------------------------------
when accessing the vshell, I noticed /dev/loop0 is 100% utlized. could this be the issue? and what is the solution for it ?
-----------------------------------
vManage:~$ df -kh
Filesystem Size Used Avail Use% Mounted on
tmpfs 64K 0 64K 0% /dev
/dev/hda1 5.0G 2.0G 3.1G 39% /boot
/dev/loop0 1.1G 1.1G 0 100% /rootfs.ro <<<<<<
/dev/hda2 15G 3.5G 11G 25% /rootfs.rw
aufs 15G 3.5G 11G 25% /
shm 16G 336K 16G 1% /dev/shm
tmp 1.0G 168K 1.0G 1% /tmp
tmpfs 16G 264K 16G 1% /run
/dev/hdb 98G 3.2G 90G 4% /opt/data
tmplog 120M 4.0M 117M 4% /var/volatile/log/tmplog
cgroup 16G 0 16G 0% /sys/fs/cgroup
svtmp 1.0M 584K 440K 58% /etc/sv
-----------------------------------
Thanks & Regards,
