SD-WAN and Cloud Networking

In my environment we have multiple cEdge devices, 1 vManage, 2 vBond and 2 vSmart.Due to some reasons one of the cEdge devices lost connectivity to vMange. Not sure of the exact reason.But would like to understand, will there be any impact due to thi...

In my environment I have 2 vSmart controllers. (vSmart-1, vSmart-2)In cEdge-1, the OMP peer is established only with vSmart-1. No details about peering with vSmart-2.in cEdge-2. the OMP peer is established with vSmart-1, for vSmart-2, the status is i...

Is it possible to mark a variable as optional in sd-wan cli template?Can we use variables in a local data policy? I want to apply an ACL to internet facing interface that only permits traffic to the internet facing IP only. Policy will be applied to ...

We have a Cisco hosted SD-WAN fabric in a shared environment meaning we are a tenant that uses shared control components. There is a c8000v hosted in AWS that we onboarded and has active control connections to vBond and vManage. For some reason I'm n...

In scenarios where there are 2 vBonds, how the redundancy works ?In normal scenarios, are both the vBonds are active - active or active - standby.How the redundancy works in case of failure of 1 vBond ?

For the below commad in cEge, in normal scenario it should show only vSmart and vMange.Plse claify if myunderstandng is correct ? Does vBond will be visible in the output ? show sdwan control connections 

If a cEdge has 2 internet connections & there are 2 vSmart & in this scenario how many control connections will be establisehed.Will it be 4 or 2 ? 4 means each internet link IP wll form connection with both the vSmart, so there should be 4.Is my und...

Sign up for the SD-WAN Interconnects EFT today! We’re thrilled to announce that SD-WAN Interconnects is now available for private beta & early field trial (EFT). Customers using both Meraki and Catalyst SD-WAN can now enable transit between VPN fabr...

I am having a difficult time setting up a proper multi-regional fabric. In a typical SDWAN Fabric, any service VPN prefixes get advertised to other edge routers running the same service VPN by default. But when the routers and an associated TLOC are ...

In my topology, I have my vmanage connected to a cisco router, where the router acts like a VPN server.There is a windows machine too which is able to receive the updates from the NTP server and also accept its. However, my vmanage, receives the upda...

We are deploying an SD-WAN environment in a HUB-Spoke configuration, where tunnels from the Site to the HUB and to other Sites are up. When a tunnel between Sites goes down, we want to be notified through some means. Do you know if there's any way to...