hello, So in my lab i just have 3 CEDGE (CRSv) and i want to connect them to the controllers the only consideration is that the link are MPLS ONLY or in this case i put gi1 color private1 and gi2 color private2 on the SDWAN-DC device and i created r...
The route learned by OSPF from the LAN is re-distributed to OMP for publicity to other sites.I do not want to advertise the specific routes from OSPF. What kind of 'configuration' should we use ?I want to control this in the SD-WAN Router side, not t...
Hello, team. Good day. We are planning to upgrade below platforms to 20.9.x. Is there any upgrade path ? - vEdge 5000 20.3.3 - vEdge 2000 20.6.3 - ISR1100-6G (Viptela OS) 20.6.3 Thanks.
Good morning all!I am working on a project on our SD-WAN. I am new to SDWAN and vManage and was asked to look into possibly scripting some packet captures over a period of time. Our SDWAN consists of several IR1101's and they can only be managed via ...
In my environment we have multiple cEdge devices, 1 vManage, 2 vBond and 2 vSmart.Due to some reasons one of the cEdge devices lost connectivity to vMange. Not sure of the exact reason.But would like to understand, will there be any impact due to thi...
In my environment I have 2 vSmart controllers. (vSmart-1, vSmart-2)In cEdge-1, the OMP peer is established only with vSmart-1. No details about peering with vSmart-2.in cEdge-2. the OMP peer is established with vSmart-1, for vSmart-2, the status is i...
Is it possible to mark a variable as optional in sd-wan cli template?Can we use variables in a local data policy? I want to apply an ACL to internet facing interface that only permits traffic to the internet facing IP only. Policy will be applied to ...
We have OMP route exchanged & we can see to & from packet but websites are not working which goes through proxy server over one public color where as with other public color its working
Hi, I have to pass the serial to the tac, use this command in vManage, is this the correct information or does anyone remember which command by cli, catalyst manager or both I can collect this information. Thank you very much for your help Regards....
We have a Cisco hosted SD-WAN fabric in a shared environment meaning we are a tenant that uses shared control components. There is a c8000v hosted in AWS that we onboarded and has active control connections to vBond and vManage. For some reason I'm n...
Can we use same IP Address for Sysem IP and VPN 0 of a vBond and vSmart
In scenarios where there are 2 vBonds, how the redundancy works ?In normal scenarios, are both the vBonds are active - active or active - standby.How the redundancy works in case of failure of 1 vBond ?
For the below commad in cEge, in normal scenario it should show only vSmart and vMange.Plse claify if myunderstandng is correct ? Does vBond will be visible in the output ? show sdwan control connections
If a cEdge has 2 internet connections & there are 2 vSmart & in this scenario how many control connections will be establisehed.Will it be 4 or 2 ? 4 means each internet link IP wll form connection with both the vSmart, so there should be 4.Is my und...
Dear All Friend and Experts, We have two site :Site A & BVP0 is transportVPN 10 is services VPNhoSite A has a Server IP is x.x.x.xSite B have two clien are 1.1.1.1 and 1.1.1.2Two Tunnel , Two TLOC color biz-internet and pub-internet Now my customer t...
