Choose one of the topics below for SD-WAN Resources to help you on your journey with SD-WAN
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.
I have to deploy remote side cEdge routers, the cEdge routers are at warehouse. Is there any way to configure to provision cEdge routers without vManage? how i can use cisco ca manually for cEdge routers?
anyone can suggest? help me asap.
I already replied to your other thread. You can put a file on flash or USB:
The cEdge will have a certificate already installed on it. It should also already have the root CA trust installed. As long as you have uploaded serial file to vManage, and the controllers know of this device, you should be good.
It's just a normal USB stick where you save the .cfg file. When the router boots, it will mount the USB and it searches for this file. If it finds it, it loads the configuration and stops the ZTP process.
Not that I'm aware of. Note that if the device hasn't finished booting up, it may say "login failed" when you are trying to access it.
Did you solve this?
"i have waited for bootup process to be finished and then i am trying to login with default username and password, its say authentication error. default username and password is incorrect error."
I have same issue. I installed SD-WAN image on ASR1001-HX and after installation it asks login credentials but nothing works.
Yes i have resolved this issue.
What you need to follow below steps:-
When you run "request platform software sdwan software reset " command then router reboots and when the router comes up you will login with the default username and password which is admin and admin but as soon as you login with the default username and password, you will get one message on console which says that one time default username and password removed you will have to create new username and password (something like this error).
Create new username and password for that router.
use following command:-
username admin privilege 15 password admin@123 (Note:- you can change the username and password using this command)
For the routers those are already have these problem you can follow the password recovery process go to rommon mode from there you can change the username and password
But for the brand new router use the first step which i said which is create default username and password after "request platform software sdwan software reset " command.
Kindly let me know if you have any issue with in it or any issue related to SD-WAN viptela.
If you think that my post has helped you kindly hit the helpful button.
Thanks and Regards,
I wasn't yet run "request platform software sdwan software reset ". So when I booted the device it came up with default user, so I didn't need to go to ROMmon. I created the admin user and ran "request platform software sdwan software reset ". Admin user was reset to default, and after login the admin user was deleted again. So I needed to create it again. After all this there was no more problems.
"request platform software sdwan software reset " command adds packages.conf with SD-WAN bootfile in bootvar: BOOT variable = ...