Accepted Solutions
1) Some of the built in activities are actually atomics, which you can dig into the individual activities that make it up. However you can not inspect the code for the base activities. If it's an atomic, you can drop down and do Modify Atomic Action to see the individual activities that make up that atomic.
2) For building your own atomics you certainly can. Essentially you build it out as a new workflow and then under the workflow properties you'll set it as an atomic and put it into a group after validation.
Then your new atomic will be listed on the side as a new "Activity"
If your ACI is based on prem, there's a new SecureX Orchestration Remote you can use with SXo to reach its API interface.
1) Some of the built in activities are actually atomics, which you can dig into the individual activities that make it up. However you can not inspect the code for the base activities. If it's an atomic, you can drop down and do Modify Atomic Action to see the individual activities that make up that atomic.
2) For building your own atomics you certainly can. Essentially you build it out as a new workflow and then under the workflow properties you'll set it as an atomic and put it into a group after validation.
Then your new atomic will be listed on the side as a new "Activity"
If your ACI is based on prem, there's a new SecureX Orchestration Remote you can use with SXo to reach its API interface.
