cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

New Hall of Fame Member-Peter PAluch

153
Views
0
Helpful
4
Replies
Highlighted
Beginner

802.1x Printer Port Drops When Printer Is In Sleep Mode

Hello

I have 802.1x configured on my Cat 3560 switch stack. For the most part everything works fine but I keep running into users who have printers that go into sleep mode and then the port reverts to a dead default vlan99. When the user goes to print to the printer it is unable to come out of the default vlan99. Below is how I have the port configured. Has anyone else experienced this problem? If so how did you fix it?

 

interface GigabitEthernet1/0/1
switchport access vlan 99
switchport mode access
authentication order dot1x mab
authentication priority dot1x mab
authentication port-control auto
authentication periodic
authentication timer reauthenticate server
mab
dot1x pae authenticator
dot1x timeout server-timeout 30
dot1x timeout tx-period 3
dot1x max-req 3
dot1x max-reauth-req 3
spanning-tree portfast
spanning-tree bpduguard enable

 

Everyone's tags (2)
4 REPLIES
Contributor

Re: 802.1x Printer Port Drops When Printer Is In Sleep Mode

change them

authentication order dot1x mab
authentication priority dot1x mab

 

into

 

authentication order mab dot1x
authentication priority dot1x mab

 

these above commands are for devices which are dump. i mean those not support dot1x/or dont have a supplicant. the order of authentication will be mab than dot1x.

 

 

please do rate if i help you.

 

 

Contributor

Re: 802.1x Printer Port Drops When Printer Is In Sleep Mode

were you able to fix your issue?

Beginner

Re: 802.1x Printer Port Drops When Printer Is In Sleep Mode

Sheraz,

This has seem to stabilize the printer. I applied the config change to the printer port after that I bounced the port and it has been stable.

Contributor

Re: 802.1x Printer Port Drops When Printer Is In Sleep Mode

kindly please mark this answer you other can benefit from this too.

 

thank you

CreatePlease to create content
Content for Community-Ad

Blog-Cisco Community Designated VIP Class of 2019