cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
225
Views
0
Helpful
3
Replies
Highlighted
Beginner
Beginner

FC4210 and SMC2210 10G interface

We a have provide Cisco Stealthwatch X710-DA2 dual-port 10G SFP+ NIC on FC4210 and SMC2210 10G interface. 

So Can we used 10G SFP+ Port for Management and Collection 

3 REPLIES 3
Highlighted
Cisco Employee

Re: FC4210 and SMC2210 10G interface

Data receive port and management port are different.

Please check the below datasheet that explains port configuration with the picture.

 

FC4210:

https://www.cisco.com/c/dam/en/us/td/docs/security/stealthwatch/m5/hw/SW_FC_4210_Spec_Sheet_DV_1_1.pdf

 

SMC2210:

https://www.cisco.com/c/dam/en/us/td/docs/security/stealthwatch/m5/hw/SW_SMC_2210_Spec_Sheet_DV_1_1.pdf

Highlighted
Beginner
Beginner

Re: FC4210 and SMC2210 10G interface

It is Port 3 and Port 4 for FC4210It

FC4210.pngand Port 3 For SMC2210FC4210.pngSMC2210.png

Highlighted
Cisco Employee

Re: FC4210 and SMC2210 10G interface

Yes, that's correct. Apologies, my previous answer is not clear, I mean physical port location is fixed so we can use port3 for management and collection, and port4 for additional collection but we can't use port4 for management in FC4210. SMC2210 is the same, we can only use port3 for both management and collection but we can't use port4 for these functions.

This widget could not be displayed.