cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
298
Views
0
Helpful
5
Replies
Highlighted
Beginner

Stealthwatch SMC failover

Hi Team

 

I trying configure StealthWatch Failure on Two SMC Primary and secondary, I follow all steps under the Online help tool.

I have Trial License full, and start Failure mode by Seconday SMC:

 

01.JPG

Both SMC* Have Trial License OK

 

02.JPG

I start Failure test under SMC2 Secondary Console***

 

03.JPG

Under SMC Primary console Didnt Show me anything about primary mode

 

04.JPG

 

Under Secondary I see that Secondary change right but didnt stablish with Primary

 

Someone already get this issue?

 

 

Everyone's tags (5)
5 REPLIES 5
Highlighted
Cisco Employee

Re: Stealthwatch SMC failover

I don’t fully understand your failover scenario but it looks something wrong not shown primary SMC in secondary SMC UI.

 

So please contact TAC team, they will help correct failover procedure and if this issue was made by a defect, they also cover it.

Highlighted
Beginner

Re: Stealthwatch SMC failover

Simple Failover scenario!

 

08.JPG

Highlighted
Cisco Employee

Re: Stealthwatch SMC failover

So, you shutdown SMC1(or disconnect SMC1 from network) and SMC2 is promoted as primary. So turn on(reconnect) SMC1 and you promote SMC1 manually in UI as primary for fail back if you want SMC1 to be primary. This should work.

 

If you still have an issue, please contact TAC team.

Highlighted
Beginner

Re: Stealthwatch SMC failover

Hi Friend I tryied today again and follow your tips, but even when I shutdown SMC1 and try manually upgrade SMC2 on Primary didnt work.

 

SMC2 wont able tu push FC and devices from SMC1

Highlighted
Cisco Employee

Re: Stealthwatch SMC failover

Please open TAC case. It looks something wrong.