We're pleased to announce that AnyConnect is macOS High Sierra (10.13) compatible.
Our recommended version for High Sierra is 4.5MR2 (4.5.02033), available today 9/25/17. This version includes additional guidance to ensure that the AnyConnect Kernel Extension (KEXT) is properly approved by the end user. This is a new requirement in High Sierra.
4.4MR4 and 4.5MR1 have also been tested for High Sierra compatibility, but will provide no further guidance to the end user (beyond the single OS prompt) that manual steps are required to provide full AnyConnect capabilities. Additionally, with these older (compatible) AnyConnect releases, a reboot may be required after manually approving the AnyConnect extension to continue to run. This step is not required with 4.5MR2.
Note: Customers using Host Scan must be running version 4.3.5038 or later of the module in order to detect the presence of the macOS 10.13 firewall.
We will continue to look at any way we can optimize this experience in subsequent maintenance releases.
Hi Guys, just want to double check with you. In FTD, I have 2 subnet and if I need to have intervlan for those 2 VLAN, do I still need to configure an identity NAT or any NAT?My target is doing intervlan routing between the 2 VLAN without any IP change.th...
Hi,I set up DVTI in EVE with 2 routers. HUB------SPOKE.Virtual-template is not showing up/down. Instead of up/up.Checked Phase1 and Phase2 parameters but not sure where I made a mistake.Attached diagram and configuration.Please take a look.
I tested using both Cisco ISE 2.4 (patch 9) and Cisco ISE 2.6 (patch 1). I have a user who successfully authenticated via RADIUS against ISE. Under ISE, Operations > Live Logs (and Live sessions), I see the user authenticated. After the accounting requ...
Hello,I would like to download ESA software for C695. But I cannot find any versions for this model.https://software.cisco.com/download/home/282509130Does anyone know how to find it and download it? Thank you!SH SHAO