We're pleased to announce that AnyConnect is macOS High Sierra (10.13) compatible.
Our recommended version for High Sierra is 4.5MR2 (4.5.02033), available today 9/25/17. This version includes additional guidance to ensure that the AnyConnect Kernel Extension (KEXT) is properly approved by the end user. This is a new requirement in High Sierra.
4.4MR4 and 4.5MR1 have also been tested for High Sierra compatibility, but will provide no further guidance to the end user (beyond the single OS prompt) that manual steps are required to provide full AnyConnect capabilities. Additionally, with these older (compatible) AnyConnect releases, a reboot may be required after manually approving the AnyConnect extension to continue to run. This step is not required with 4.5MR2.
Note: Customers using Host Scan must be running version 4.3.5038 or later of the module in order to detect the presence of the macOS 10.13 firewall.
We will continue to look at any way we can optimize this experience in subsequent maintenance releases.
Hello I'm running ISE 2.4 and I'm trying to get NAC via dot1x/radius working. I have a NX-OS 9K switch in my network devices with correct radius key. I also have a default policy set to accept dotx wired users and allow them to do anythin...
Hi, when we install cisco anyconnect on PC Map network drive disappears although port might has no ISE configuration so no authentication from ISE or posture check, map network driver might not disappear from installation but it will disapp...
Hi, I have to apply Cisco Smart License for FTDs through FMC but my FMC cannot get access to cisco server for registration How we can make my FMC to get access to internet. Need your help please !!!!!!!!
Is there a way to use certificates in order to login to the sponsor portal of ISE? I know it's possible to access the admin UI using certificates, but my customer would like to have the same ability to access the Guest Sponsor Portal.
Hello, I have a problem with CSM. The disk is full. I noticed it when the event viewer did not show logs and then I was not able to login. I can see that the log rotate is working fine. Any hints? Regards,&...