For more question so I will provide you more information design Firepower 2130 , and proposed catalyst 9400 with sup1 that design to use VRRP or HSRP, but at the nexus5672UP side design for vPC and I design to connect the network diagram as attach ? I would like to connect the diagram as I attach because I have only 4 port 10G for each firepower (I can not propose stackwise license and addition network module for firepower because the budget is limited)
For the 4 port 10G I use as follow. 2 port for inside and outside, 1 port for failover and 1 port for stateful failover.
If my customer do not have much traffic and from the firewall throughput is 4.75 Gbps, Can I design stateful failover link for 5 Gbps and failover link 5 Gbps with etherchannel port
Please see my diagram below. For the firepower if one interface down the secondary unit will active immediately right ?
So I think the diagram should below recommend please.
I have tunnels on a cisco router 4221but i wanted traffic from 1 tunnel to be Natted and leave the rest,.i used a route map on a static NAT. but when i enable the route map on the ip nat other tunnels pass traffic through very well, but refuses on the oth...
Hi Folks, I have some problems and confusion with IPSec phases and Ike version and relationship with fqdn.I can set up tunnels but I'm not sure how troubleshootingIf you have any resources or documentations for that please update me
Looking for recommendations on guest/certificate issues on our ISE self registration portal, my certificate knowledge is pretty limited and just getting into using certificates.This is only for guest users and contractors to avoid getting annoying certifi...
Advanced Phishing Protection - Help on Domain Tag. 1. Does it enough to tag domains for only Internal, Service and Partner to start with APP policy enforcement ?2. What's the difference between the below tags and give an example.Internal / Service / ...
Dear Team,FMC/FTD version: 6.3 we have setup a virtual lab of FMC/FTD, and trying to setup a RA VPN, configured RA VPN wizard and while deploying on FTD, we are getting these errors. please help us =========SNORT APPLY================...