Recently there were quite a few blog posts on VPN forums relating to troubleshooting common issues in IPsec VPN.
Ankur & others have posted a few nice articles.
I do find, however, that to troubleshoot core issues of IPsec VPN - be it a mis-configuration or a bug - you need to know how the protocol works.
And even if you do, different devices behave differently and provide different outputs.
What have I been up to
Over the course of last few months I have been trying to make it easy for wannabe troubleshooters to diagnose and enable to correct themselves common issues of IPsec VPN.
To do this however, let's recap what you should know about IKE
High level view of IKE version 1 exchange
As many of you know IKE version 1 has following modes:
- Aggressive mode
- Main mode
Aggressive mode is typically used for EzVPN when using pre-shared key (PSK).
Main mode is the mode we use when establishing Lan-to-Lan/DMVPN/SVTI tunnels or ezvpn with use of certificates.
Note that I refer to messages below, not packets. This is a common misconception, a message might need multiple packets to be sent.
Aggressive mode needs 3 messages to establish phase 1 association and additional 3 to establish IPsec SA to be able to pass traffic (called Quick Mode - QM).
Main mode exchanges 6 messages to establish phase 1 and again additional 3 messages to finish Quick Mode - same way as in aggressive mode.
The main advantage of main mode is that it is more secure. Aggressive mode will exchange your pre-shared key in a hashed form, but not encrypted. That is why to improve security users are required also to provide their username and password.
Result of my work.
The result of my work is a few articles to cover the most common deployments.
The intention is to help troubleshooters map CLI commands to messages in debugging and vice versa, understanding how messages in debugging map to configuration.
The documents will also serve as reference for people who would like to know how successful debugging session looks like.
Based on them you might be able to find where your session breaks.
Hopefully this help of those they will be able to spot problems without involving TAC. ;-)
Hi all,I have a VPN site-to-site configured sucessully on CISCO ASAThe local network is 192.168.0.0/24 and the remote network is 0.0.0.0 (any) But, now I need that a traffic to a specific destination doesn't enter that tunnel. It can not flow through...
Hello,I am at ISE 2.4 patch 8 and am going to install patch 11 in the near future. I have downloaded patch 11 and found it to be 2.39 GB in size. I am wondering if anyone has already made this change and how long did the patch 11 take to complete the inst...
Hello, I have created my Realm and its enabled -I have added the directory server from the Active Directory domain as an agent and its reporting as working ok. I have the cisco agent installed on the agent server I have created the identi...
Self-Signed SAML certificates have expired on all ISE nodes, whilst SAML is not currently in use in the environment the alerts are somewhat irritating. Try to generate a new Self-Siged SAML cert and it creates fine on the Primary Admin Node but ...