The Anyconnect Essentials is a license that allows you to connect up to your 'Total VPN Peers" platform limit with AnyConnect. Without an AnyConnect Essentials license, you are limited to the 'SSLVPN Peers' limit on your device. With the Anyconnect Essentials License, you can only use Anyconnect for SSL - other features such as CSD (Cisco Secure Desktop) and using the SSLVPN portal page for anything other than launching AnyConnect are restricted.
You can see your limits for the various licensing by issuing the 'show version' command on your ASA.
2) Is there a separate AnyConnect Essentials client needed on the ASA if I already have Anyconnect installed?
A: No. Anyconnect Essentials is just a license - there is no separate client needed.
3) How do I enable the AnyConnect Essentials license?
Instructions for installing the license key will be included when you get the license. Once you've installed the key and rebooted, running the 'show version' command should indicate that the license is enabled. You should see output similar ot the following:
AnyConnect Essentials : Enabled perpetual
Once that is there, you turn on the license by doing the following:
4) So I can't use the portal page at all with AnyConnect essentials?
A: The portal page exists, but once logging in you will immediately launch AnyConnect. Other features (bookmarks, java plug-ins, etc) will not be available.
5) What version of ASA code do I need for AnyConnect Essentials?
A: ASA 8.2 and above support AnyConnect Essentials.
6) Exactly which features are supported by AnyConnect Essentials vs Anyconnect Premium Licensing?
Hello, Could someone please help me out here:I have a 5506x at my home office Software Version 9.9(2), and to provide Internet access I add a PAT rule. I Also need to fwd a port and after creating the access rule I also created the NAT rule for that....
Hello I have problem with flaping trunel between Router and tow ASA firewall Here is my configuration with Router hostname Router!boot-start-markerboot-end-marker!vrf definition Mgmt-intf!address-family ipv4exit-address-fa...
Hi all, I have an FTD 6.3 on Firepower 4110. It is configured in routed mode with "the usual" configuration: outside, inside, DMZ, and serverfarm interfaces/zones with traffic allowed out but not in. I also have AnyConnect services for rem...