The Adaptive Security Appliance (ASA) can lose connectivity to the Websense server in these two situations:
When the IP connectivity to the server breaks
When the service on the server stops
In both these cases, the ASA does not try to reconnect to the server. A packet capture on the ASA interface does not indicate packets that go out towards the Websense server in an attempt to reconnect.
To resolve the problem, perform these steps:
Remove the url-server command.
Re-apply the url-server command.
This problem is fixed in versions 7.0(5), 7.3(0.1), 7.2(0.40), 7.0(4.13), and 7.1(2.1).
For more information, refer to Cisco bug ID CSCsd02938.
Hi guys I have 2 ASA firewalls active/standby version 9.8(2) by ASDM I change the security level of the interface from 100 to 0then I found this message in below photo I didn`t read the message I want to finish this task quickly so I ...
I ma using Cisco ISE 2.6. I have enabled TLS 1.0 and TLS 1.1 in current deployment. Now i need to disable TLS 1.0I wanted to know that in my network is there any end device that using TLS 1.0, how can find that?Is there and recommendations for security se...
Greetings, First time doing ZBF configuration for brand new C1111x, and after reading posts here and on Cisco docs, with a simple target to grant users internet connection and block connections from outside to the router I did the following: int...