The PIX does not allow a Telnet session to any interface from a host off any other interface. For example, you cannot Telnet to the inside interface of the PIX from a host off the outside interface of the PIX. You can only Telnet to the outside interface from a host off the outside interface, and that traffic must be through an IPsec tunnel.
Complete these steps:
Enable Telnet to the outside interface with the telnetnetwork number subnet maskoutside command.
Configure an access list that defines interesting traffic to include traffic from the outside interface of the PIX to the remote subnet. Refer to this partial PIX configuration for an example:
access-list VPNTUNNEL permit ip 10.1.1.0 255.255.255.0 192.168.0.0 255.255.255.0 access-list VPNTUNNEL permit ip host 10.10.10.1 192.168.0.0 255.255.255.0 ip address outside 10.10.10.1 255.255.255.0 telnet 192.168.0.0 255.255.255.0 outside crypto map MYMAP 20 match address VPNTUNNEL
For PIX/ASA version 7.x use extended access-list. For example:
Hi all, On an ASA 5505, is there a way to limit the bandwidth per user unless there is little activity, which would then allow the user more bandwidth. For instance, if I have a 100mb internet link, and give all connections a guaranteed 10mb, co...
I'd like to seek your help about ISE McAfee automatically remediation.
I want to check the mcafee definition version and automatically remediate the definition version by using anyconnect posture, after configuration in ISE, I rollback ...
I am converting a existing ASA to FMC/FTD (6.4) and using the Firepower migration tool (v. 1.3.1-3051). During the "review and validation" I am wanting to change the mgmt IP (Diagnostic1/1) so that it doesn't overlap with the existing production ASA...
HiI run an MPLS backbone and try to find a way to implement Cisco GET VPN.For historical reasons, we have MPLS running on the CE devices at the customer site. That means the whole path from the customer site A, through our core till customer site B is MPL...
Have run through the steps on the EVE support site. Sometimes the device gets an IP and the GUI comes up, but will not allow me to login.Sometimes the device does not get an IP at all. I'm running the lab from my PC which is an i7 with 16GB of RAM and a 1...