Once all requirements are met, issue these commands on the PIX:
hostnamedomain-name !--- Generate a key for the SSH encryption to use. ca generate rsa key 1024 !--- Allow the desired host to connect to the PIX on the interface specified. sship_address mask interface !--- Save your configuration. ca save all write memory
This is an example:
hostname mypix domain-name cisco.com ca generate rsa key 1024 ssh 10.0.0.0 255.255.255.0 inside ca save all write memory
Occasionally, when a username and password is provided in the SSH client, an SSH window appears and then disappears. In order to resolve this problem, issue the ca zeroize rsa command in order to remove any existing RSA keys on the PIX. Then, issue the ca zeroize rsa command again in order to regenerate the RSA keys.
If the PIX is configured for port forwarding with the static command, for port 22, then the configuration of the SSH to the PIX does not work.
In PIX version 7.0 and later, this is the command needed to generate RSA key:
Good evening, I am a newbie and I am asking if someone can help me with two problems? I am having a headache trying to connect with the VPN client using the Outside interface and I am trying to access an internal host from the outside over AnyConnect...
I have the following in my crypto map configs on an ASA for an IPSEC tunnel:crypto map out_map 1 set ikev2 ipsec-proposal prop1 prop2 aes256 prop3 As you can see there are 4 proposals referenced I believe when the other side of tunnel/peer only has 1...
Hi there I have a new C2960X that we are replacing a couple old ones with.I can not get RADIUS working . yes the switch can ping the radius server .. i took out the key but it is there HELP I have it programmed like thisaaa new-...
Anyconnect VPN has stopped working. Running on windows 10 homesecurity services: Windows security & malwarebytesanyconnect version: 4.6.03049 multiple install/reinstall from company IT page, turning off windows security firewall, runnin...