This document is intended for Cisco field engineers, technical marketing engineers, partners, and customers deploying Cisco StealthWatch 6.7.1 with Cisco platform exchange Grid (pxGrid) using Cisco Identity Service Engine (ISE) 1.3 or higher.
This document assumes that StealthWatch and ISE are already installed and provides the following:
Customized pxGrid template creation for both the ISE pxGrid node and the SMC (StealthWatch Management Center)
Configuring ISE for pxGrid node operation using either Certificate Authority (CA)-signed certificates or self- signed certificates
Configuring the StealthWatch Management Console (SMC) as a pxGrid client using either Certificate Authority (CA)-signed certificates or self-signed certificates.
Configuring the StealthWatch Management Center (SMC) for Cisco (Adaptive Network Control) ANC pxGrid mitigation action.
Hello, Could someone please help me out here:I have a 5506x at my home office Software Version 9.9(2), and to provide Internet access I add a PAT rule. I Also need to fwd a port and after creating the access rule I also created the NAT rule for that....
Hello I have problem with flaping trunel between Router and tow ASA firewall Here is my configuration with Router hostname Router!boot-start-markerboot-end-marker!vrf definition Mgmt-intf!address-family ipv4exit-address-fa...
Hi all, I have an FTD 6.3 on Firepower 4110. It is configured in routed mode with "the usual" configuration: outside, inside, DMZ, and serverfarm interfaces/zones with traffic allowed out but not in. I also have AnyConnect services for rem...