Although sysopt connection permit-ipsec is in the configuration, traffic does not seem to flow between the site-to-site VPN unless the traffic between the subnet in the access list bound with the inside interface is allowed. If there is no access list on the inside interface it works fine. The sysopt command only bypasses the checking of the outside access list.
Traffic won't flow through the VPN unless it is permitted in the inside interface access list even if sysopt connection permit-ipsec is configured
Allow the tunnel traffic in the access list bound with the inside interface or remove the access-groupaccess-list in interface inside command.
For additional information on how sysopt works with different versions of PIX Firewall code, refer to the relevant documentation for your PIX release:
The Customer Connection signup page is broken, or I'd have put this there. (The required "Country" dropdown has no entries and the form won't submit without it. This is on Chrome) The consensus from my user community so far is that they don't like it...
Hi, Does any one here have experience on the firepower, the results on the intrusion events have "would have dropped" and "drop"? One IPS signature but two results drop and would have dropped. the firepower are configured on inline mode. Any one...
Hello there, I created a NAD profile for Pica8 switch, now when I create an authorization profile I see the ACL and VLAN fields under the common tasks section but there is no DACL field shown. What should I do in my NAD profile to display the DACL fi...
I purchased a Pix 506 that has a password configured on it, a password that I do not know know. I've done some research and found that I need the file referenced in the title (np52.bin) to complete the recovery process and hopefully gain control of the de...
I swear this sub interface used to give out addresses from this pool without issue. Something got wrecked though.Here's the interface + sub interface config:interface GigabitEthernet1/3