Adds RADIUS CoA support on AP and modifies MAB parameters. Tested with Aerohive AP330 running HiveOS 6.5r8b.179369. On ISE, Auth VLAN feature was used for URL redirect and advanced flows (CWA, BYOD, Compliance). Few notable settings on Aerohive AP:
Enable Captive Web Portal: Unchecked
Enable MAC Authentication: Checked
Authentication Protocol: PAP
User Profile Application Sequence: SSID-MAC Authentication - Captive Web portal
Note: To reduce number of ISE policies, ISE can return VLAN ID sent from the AP RADIUS attribute ‘Aerohive:Aerohive-User-Profile’ for access VLAN ID for authorization.
Hello all,I have what I think is a fairly simple question. Will adding stateful failover to an already existing failover HA pair on the ASA disrupt any services on the firewall? I was looking at the failover pair and noticed that the 'failover...
I can not for the life of me see where I set the DPD timers when using IKEv2 on the ASA. All of the Documentation and guides seem to only talk about it using IOS and/or FlexVPN. does anyone know what the command is?
Hello, I've noticed that the installation of AMP enabler module in AnyConnect does not use the local machine proxy configuration no matter whether I configure the proxy in the AMP policy or not. Is there any way to force the connector to use the prox...
HiWe have an ASA firewall in a HA setup and currently are moving over to a new internet circuit that is provided by the Data Centre. Previously the Public range extended out to the next hop address so the VPNs terminated on the outside interface.However n...
vpHello, I've been asked to configure the following set-up :The traffic comming to 22.214.171.124/32 needs to be NATed and forwarded to 10.133.8.28, across a site to site VPN.I'm using an ASA firewall (left side) and a Palo Alto firewall (right side). ...