This document explains how to configure LDAP on ASA so that user has "monitor only" access to ASDM.
Ensure that you meet below mentioned requirements before implementation.
Define ASA as a AAA client on LDAP server.
Define the IP address and an identical shared secret key on the LDAP and ASA.
The information is based on below mentioned software and hardware versions:
All of the devices used in this document started with factory default configuration.
Configuration on ASA:
1.) AAA server configuration
2. LDAP attribute map configuration:
3. AAA configuration on ASA
User have configured the ASA CX and configured the Web filtering policies.
In the policies, he has created the user objects for each of his user with their IP address for the Source. But he need to integrate it with Active Directory which will be easy for him to add user in the object group by
their domain username. what will be the steps for it.
And also that can be easily identified in the event tab with that username, as for now its just showing me the IP of the user doing illegal surfing.
You will need to setup/install CDA instead. CDA provides several benefits over the older AD Agent such as, GUI interface for management, runs on its own VM - doesn't need to be installed on a DC, and
Windows 2012 support. Below is additional information regarding CDA for you to review: Once you install CDA on your network Please follow the installation guide for Active Directory Integration. Once you done, you can see the user name on access policy.
Hi,I'm having a problem routing LAN traffic out through the firewall. I've read the multiple posts with the same problem but their solutions have not worked for me. Traffic flow isInternet - Cisco ME3400 - Firepower2110 (ASA) - Switch - PC Netwo...
We are on ISE 2.4 and have configured AD <> ISE integration using WMI (to get information of AD users) Some providers suddenly went offline for no reason, we had to manually add back integration Is there a way to set an email alertin...
Hello, I recently tried to upgrade my ESA (virtual appliance) from 13.5.3-010 release to the latest GD release 184.108.40.2062/Once i download the stuff, and try to install , few seconds after i have the following kind of error (attached an extract) ...
For some reason the router does not recognise “AnyConnect-eap” command at all? it’s a 2921 15.2 iOS and has securityk9 and base? I can only use “eap query-identity”? does this only work on IOS-XE?I’m in process of setting up flexVPN remote ...