I have a requirement to create two IPSEC Site-to-Site VPN's as primary and secondary between three different locations.
Loc1: is Primary Data Center
Loc2: is Secondary Data Center
Loc3: Support Center
Note: Loc2 is a DR Setup, if Loc1 is having any probloem with out any outgate or manual interption, from the backup Data Center, all the opertaions should work.
From Loc3 am creating a site-site VPN tunnel to Loc1 this is the primary one. from the same Loc3 am creating another site-ste VPN tunnel to Loc2 as a backup. If the primary will goes down, automatically the backup should srart work from the Loc3.
The complete setup and IP Network is same In Loc1 & Loc2 except the Internet connectivity.
Hi,I haveone ISE (PAN+MNT )Node in DC andanother ISE (PAN+MNT) node in DR .And I have one AD domain in DC and another AD domain in DR. And I have two node groups deployment for branch sites with each group contain two PSNs.What I would like to know i...
I am going to disable remote access traffic across my network except my whitelist. I am using Cisco Firepower as well as Cisco ASA in my network perimeter. How and where should I put my rule/policy to enable this capability?
Hi Guys, I currently have Cisco Anyconnect with Split tunneling. Everything seems to be working fine. Is there a way to force clients when they try to connect to an IP address 220.127.116.11 and his/her traffic would go back to t...
I would like to know if there was a way to collect username, hostname and operating system info from our anyconnect users. Currently we have syslog enabled that tells us what time users connected etc but we would like to get more info like the hostn...
HiWe generated a Cert request using IIS from a CA (wild card Cert) and I am stuck on how I can also use this wildcard on ISE 2.4, can someone help me with the steps, the same Wild card CERT is also being used on our Juniper device but am stuck with ...