By using the Cisco VPN Client, sometimes I cannot access my networks (e.g. failed to ping the network) after the VPN tunnel established. Until I have disconnected and re-connected it again, the problem is solved.
Hardware : Cisco 3825
IOS : 12.4(17b)
Image file : c3825-advseurityk9-mz.124-17b.bin
VPN Client : Cisco VPN Client 5.0.07
Any suggestions and comments are very appreciated.
This is regarding the internal networks that need to be configured in Umbrella. I have a network where my 10.0.0.0/16 is used primarily at one site, and have another subnet in this range (10.0.2.0/24) used at another site. If I add both internal networks ...
Hi everyone, Is there anyone who had luck establishing a GRE tunnel to smoothwall? My interface still shows up/down and its hard to find a resource on how to configure GRE tunnel on these devices. Appreciate if you can point out my mistake. Tha...
We recently installed a new 1GB internet circuit. When we connect directly to the router we average 900 to 950MB. When we connect the router to the outside interface of the firewall and test internet connectivity we our average spe...
I am working to configure a Cisco IOS based AnyConnect IPsec VPN. This requires us to use MSCHAPv2 and forward to an additional RADIUS system, which is Windows NPS in our environment.I have the Duo 2FA working correctly, however when the Access-Accept is ...