The Cisco VPN Client is unable to connect to the headend device and receives the Sev=Warning/3 CVPND/0xE340000D error message. The Cisco VPN Client is unable to enable the virtual adapter because it cannot set the IP configuration to registry warning
It is possible that Windows did not fill in all the information needed in the registry when it installed the virtual adapter. Setting this manually triggers Windows to initialize what it missed the first time. Sometimes, these warnings are also found:
Sev=Warning/2 CVPND/0xE3400014 The VPN Client could not find the adapters GUID - Virtual Adapter's tcpip GUID failed: 2.
Sev=Warning/2 CM/0xE310000A The virtual adapter failed to enable
To resolve this issue, perform these steps:
Go into the Network Properties and find the Cisco Systems Virtual Adapter.
Open it and assign it an IP address manually. Any IP address can be assigned.
This triggers Windows to initialize what it missed the first time.
hi,i configured an ASA FW for anyconnect RA VPN with two VPN policies/profile: a group policy (and a tunnel-group) for FULL TUNNEL and another for SPLIT TUNNEL.how do i "hardcode" to consistently display the FULL TUNNEL group/profile on the anyconnect pop...
Hi ISE pros,I already did some stuff with the ISE and always successfully avoided the MDM integration topic somehow.Unfortunately, I cannot avoid it my whole life - therefore I have some questions around it - especially SCCM integration.I checked the guid...
Hi ,I would like to know IP and mac address filtering.i have the one webserver.So i would like to restriction to access to web server.I would like do the whitelist to access webserver. i would like to do both IP and MAC filtering to access server.for exam...
Hi experts, i have an ise setup, primarilty used for tacacs. wireless 802.1x needs to be added on the setup. required configuration was done but when user try to authenticate, it will always show authentication failure. its on smart licensing. attach...
Hi Guys, I am trying to configure a Fiber port in FPR-2100 series but the lights on the port is not turning green, it stays amber all the time.- I have connected a SFP to the port and connected a cable from the Fiber port to the switch but the light ...